How To Install Light Post In Front Yard

Slide the cable through the bottom of the light post until it exits through the top.

How to install light post in front yard. Add conduit to the elbow in the post hole long enough to protrude 6 inches above the ground. Position the new aluminum post in the old hole. It can illuminate your path to the front door. Here is how to replace the fixture portion of your outdoor lamp.

Insert the wires back into the post. Slide the shaft of the post over the conduit pushing it about 12 inches into the concrete. Using a shovel dig out around the post and remove the current post from the ground. Over time and due to weather fluctuations the fixture on the top of the lamp post can begin to break down in both appearance and functionality.

How to install a lamp post in your yard step 1. Use a level to ensure the aluminum post sits plumb. Raise the post up and position it over the conduit. Going underground place the form in the hole and level it.

Put the lamp post down on the ground and pull the wires through working from the bottom to the top. If you live in a suburban community where street lights are non existent then odds are you have a lamp post at the end of your driveway. Secure the lantern to the post with the supplied sheet metal screws. Cut using wire cutters or disconnect the wiring that attaches the fixture to the post wiring.

Make sure the wires stay exposed through the top of the post as you work. Attach elbows to bring the conduit away from the house and down into the trench then up from the trench at the post. Slowly push the post into the concrete twisting it. I finally got to use this black iron pipe on some post lights that i wanted to install.

It can help you see who s calling at night and deter burglars. Where necessary cut the pieces with a hacksaw. Amazon link to great products that every diyer and handyman should kn. Dry fit pvc conduit to reach from the house to the posthole.

Outdoor lighting gives you loads of benefits. Use two work straps and wrap. Going underground the first step is to use a posthole digger to rough out a hole that is about 18 in. Fish the old wire through the aluminum post and bring it up to the top.

Secure the connections with wire caps and wrap the caps with electrical tape.